![]() |
Home | Libraries | People | FAQ | More |
The Unit Test Framework provides the decorator timeout
that specifies a time-out
for a specific test unit. The argument time
is always expressed in seconds ans wall-clock
time.
For test-cases, the time-out value sets the maximum allowed duration for
the test. If this time is exceeded, the test case is reported as failed.
On some systems, the Unit Test Framework is able to
force the test-case to stop through a SIGALRM
signal (see below).
For test-suites, the time-out value sets the maximum allowed duration for
the entire suite to complete. This duration is the accumulated time of all
the test-cases contained in the sub-tree rooted on the test-suite, plus some
extra execution time needed by the Unit Test Framework.
For each test-units under a test-suite with time-out, the maximum allowed
duration is set as being the test-suite time out minus the accumulated execution
time before the execution of the test-unit. If this test-unit is a test-case,
it is equivalent to setting the decorator timeout
to the test-case with a
time-out value expressed as before.
In case the test-suite times out, the suite is flagged as timed-out
and
failed
, and all the test
units (suites and cases) that have not been executed up to the time-out point
are all skipped.
Code |
---|
#define BOOST_TEST_MODULE decorator_11 #include <boost/test/included/unit_test.hpp> namespace utf = boost::unit_test; BOOST_AUTO_TEST_CASE(test1, * utf::timeout(2)) { #ifdef BOOST_SIGACTION_BASED_SIGNAL_HANDLING for(;;) {} BOOST_TEST(true); #else BOOST_TEST(false); #endif } |
Output |
---|
> decorator_11 Running 1 test case... unknown location(0): fatal error: in "test1": signal: SIGALRM (timeout while executing function) test.cpp(5): last checkpoint: "test1" entry. *** 1 failures is detected in test module "decorator_11" |
![]() |
Note |
---|---|
The macro |
![]() |
Note |
---|---|
The support of test suite level time-out has been added in Boost 1.70 / Unit Test Framework v3.10 |